Diskusné fórum

Čaute. Plánujem v Legacy 2010 vymeniť batériu a v servisnom manuáli sa píše, že po zapojení baterky treba držať kľúč v zapaľovaní na polohe ON aspoň 10 sek (kvôli inicializácii elektr. škrtiacej klapky), a potom naštartovať. .

Je to naozaj všetko? Netreba nastavovať okná, a podobné kraviny ako napr. u Mazdy?

Radio treba este nastavit.

Rádio? Ako?

Opäť naladiť stanice.

cau, a keby si si pocas vymeny baterky zabezpecil napajanie kablov napr. z nabijacky alebo inej 12V baterky? a nemusis prestavovat nic, auto ani nezbada ze sa nieco deje :)

Nóó, to mi veru nenapadlo. Ale zisťujem, že tie baterky vážia 15kg a neviem, ako by som na parkovisku laboroval s káblami, aby sa náhodou niečo nestalo. Potrebujem tiež poriadne vyčistiť okolie starej batérie od toho slizkého sajrajtu, ktorý z nej vrchom vytekal počas šmýkania v Škole šmyku. Nechápem, ako môže byť baterka tak netesná...

netesnosť ...aby z nej mohli odísť plyny z chcem. reakcie, inak by explodovala?

Ano to je asi najlepsie riesenie, pouzit este jednu baterku. Ak ju mas. A nemusi byt ani taka silna, ako povodna. Staci ze utiahne elektriku v aute bez startovania, napr. aj mala skoro moto, ale 12 V. Baterku si das vedla auta, startovacie kable jeden koniec na zaloznu baterku, druhy koniec na kable v aute, ktore sa pripajaju na bateriu v aute. Odpojis bateriu v aute. Vyberies, vycistis, co potrebujes, das bateriu spat alebo novu, pripojis na kable v aute. Odpojis zaloznu bateriu, odlozist. A nemusis nic nastavovat. Ked si pri manipulacii neodpojil kable od zaloznej baterie auto ani nevie, ze si odpajal bateriu.

Ked sa ti s tym nechce babrat. Tak klasika, vyberies baterku, vycistis. Das spat. Potom musim ponastavovat to, co sa bez elektriky resetlo. A pri prvom startovani pockat v polohe ON cca tych 10 sec. Ja mu dam viac casu 15-20 sec.

No,kupil som blbu bateriu, pretoze ma poly trochu daleko a kable by k nim bol natiahnute, takze ju musim vymenit za inu. .

Ale znefunkcnilo sa mi automaticke (d)otvaranie vodicovho okna, takze musim stale drzat tlacidlo. Co je toto za system???? Neviete, ako sa to nastavuje naspat?

C: OPERATION 1. RESET OPERATION A 1) Sit in the driver’s seat and close the door. 2) Turn the ignition switch to ON. 3) Operate the power window main switch to open the window glass halfway. 4) Operate the power window main switch to “UP” direction to fully close the driver’s side window glass. 5) While the window glass is fully closed, hold down the power window switch to “UP” direction for one second. 6) Operate the power window main switch to “AUTO DOWN” direction to check whether the window fully opens properly. NOTE: If the window does not fully open properly, repeat steps 1) to 6). 2. RESET OPERATION B 1) Sit in the driver’s seat and close the door. 2) Turn the ignition switch to ON. CAUTION: Turn the ignition switch to OFF and then to ON within 30 seconds. 3) Hold down the power window main switch to “AUTO UP” (with the switch fully pulled), and turn the ignition switch to OFF immediately before the window fully closes. Keep down the power window switch until the window fully closes. 4) Hold down the power window main switch to “AUTO DOWN” (with the switch fully pushed), and turn the ignition switch to ON immediately before the window fully opens. Keep down the power window switch until the window fully opens. 5) Perform reset operation A. 6) Check that the window operates properly by operating the “AUTO UP” and “AUTO DOWN” switch. NOTE: If the window does not fully open/close properly, repeat steps 1) to 6). D: NOTE For operation procedures of each component of the power window system, refer to the respective sections. • Power window control switch:<Ref. to GW-11, Power Window Control Switch.> • Front door glass:<Ref. to GW-16, Front Door Glass.> • Front regulator and motor assembly:<Ref. to GW-18, Front Regulator and Motor Assembly.> • Rear door glass:<Ref. to GW-32, Rear Door Glass.> • Rear regulator and motor assembly:<Ref. to GW-34, Rear Regulator and Motor Assembly.>